Tank Adapter C/W Tap or Valve

Brass Water Butt Connector Adapter Tank Fitting with Valve and Tap connections

Brass Water Butt Connector Adapter Tank Fitting with Valve and Tap connections

Brass Water Butt Connector Adapter Tank Fitting with Valve and Tap connections

This is a brass bulkhead tank adapter.

Complete with brass retaining nut and 2 rubber sealing washers.

The exposed male thread is 3/4" BSP. BSP threads are not the same as ruler measurements, they vary by about 1/4". Please see attached chart for approximate measurement conversions.

There are various connection options available. Please select from the drop down box.

FITTING

Firstly, you will need to drill a hole (25 / 27 mm diameter) where you want to locate the item.

IMPORTANT.....You must be able to get your hand into the tank or drum somewhere close to enable tightening of the back nut. You will also need to make sure that the area where the hole is being drilled is reasonably flat.

You will not get a good watertight seal on a heavily curved surface (a slight contour will be OK).

Once you have drilled the hole, remove the back nut and rubber sealing washer from the adapter and push the threaded section through the hole.

Then push the rubber sealing washer back over the threaded section and finish by screwing home the back nut as tight as you can by hand. Do not overtighten.

  • Weight:
    1.5kg
product review overlay image

Customer reviews

No reviews left yet
Write A Review

No reviews have been left for this product, be the first to leave a review