Tank Adapter C/W Tap or Valve

3/4" Tank Adapter to Polypropylene cased brass lever tap with twin outlets

3/4" Tank Adapter to Polypropylene cased brass lever tap with twin outlets

This is a 3/4" Tank Adapter with a 1/2" polypropylene coated brass DOUBLE outlet easy action lever tap at the other end.  

Comes complete with a  water filter and a 1/2" Snap on hose connector suitable for standard garden hose attached to both outlets (removable for cleaning as required)

It can be used with any tank or drum to provide a fully adjustable on/off tap.  With this item you can convert any suitable container into a Water butt or simply add a new or second tap where ever required.


Firstly, you will need to drill a hole (25 / 27 mm diameter) where you want to locate the item.  

IMPORTANT.....You must be able to get your hand into the tank or drum somewhere close to enable tightening of the back nut.  You will also need to make sure that the area where the hole is being drilled is reasonably flat.  

You will not get a good watertight seal on a heavily curved surface (a slight contour will be OK).

Once you have drilled the hole, remove the back nut and rubber sealing washer from the adapter and push the threaded section through the hole.  

Then push the rubber sealing washer back over the threaded section and finish by screwing home the back nut as tight as you can by hand.  Do not overtighten.

  • Weight:
product review overlay image

Customer reviews

No reviews left yet
Write A Review

No reviews have been left for this product, be the first to leave a review